Functional Features

The LCD multifunctional display window displays rich content, allowing users to grasp the basic device settings and monitor the operation status at any time. Fault alarm information is clear at a glance;

Equipped with infrared remote control (optional), achieving non-contact on-site control and parameter setting, and realizing maintenance without opening the cover;

Real time monitoring function of the actuator. After detecting a fault, the motor will stop running to protect the equipment system. In addition to displaying alarm information on the display screen, an alarm can be sent to the control system through passive contacts;

Equipped with automatic protection function for phase loss and automatic phase sequence detection and correction function, there is no need to worry about phase sequence issues on site;

By adopting advanced and original PID improved control algorithm, the success rate of one positioning has been increased. The improved PID control algorithm can automatically adjust its PID parameters based on the inertia, wear, and changes in load force (torque) of the actuator brake mechanism. The optimal stopping time for forward and reverse rotation can be calculated based on the PID parameters to ensure successful positioning once;

Equipped with over torque protection function, the actuator can be disconnected in case of malfunction;

The ZF model (optional) is embedded with support for Modbus communication protocol RTU communication mode based on 485 communication interface, and can also customize debugging in case of power failure and display function of LCD screen (built-in rechargeable battery).

Main technical indicators

Input voltage range: three-phase 342V~418V, single-phase 85V~248V;

Work environment temperature: -40 ℃ 85 ℃, relative humidity: ≤ 90RH%, can set over temperature alarm function;

Control accuracy: 0.1% 3.0% (adjustable through parameter d);

Feedback signal of actuator: potentiometer 500 Ω 10 K Ω (optional encoder factory customization);

Drive motor output: thyristor output (1200V AC, 25 A);

Analog signal input: Control motor opening signal, 4 20mA (customized before leaving the factory for 0 5V and 0 10V), with input impedance<250 Ω;

Analog signal feedback: Feedback the current valve opening signal, low drift output 4 20mA DC (customized before leaving the factory for 0 5V and 0 10V), maximum load capacity ≤ 500 Ω (2000V surge voltage);

Switch signal input: Three photoelectric isolation input control signals (remote open, close, hold), with built-in 24V control voltage;

Switch signal feedback: Relay feedback output, including fault, remote status, open position, close position output, with a load capacity of 60V/500mA;

Signal isolation: Each signal is isolated through relays and optocouplers, with an isolation level of up to 2000V.